Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Gate Installation Across San Pedro
Gate installation in San Pedro runs $1,200 to $6,500 for most residential work, with custom fabricated steel driveway gates on the higher end. That’s the honest range you should expect to see from any legitimate shop serving the hills, the flats, and the neighborhoods around Western Avenue. We dispatch background-checked, uniformed technicians to San Pedro from our Los Angeles scheduling office, and the quote you get in writing is the price you pay. For a free estimate, call (424) 757-9824.
San Pedro isn’t Torrance or Lomita. The driveways pitch hard, the lots sit tight against each other, and half the gate pillars in this town were poured when Eisenhower was president. We know exactly what that means for a gate installation, because we’ve done the work here. If you’re on a hillside off Gaffey Street or tucked into a 1920s bungalow court near Point Fermin, your gate has to fit slopes, shared rights of way, and salt air that eats cheap hinges in two seasons. Our Gate Installation team is built for that.
Why Carver Gate Repair Torrance Is San Pedro’s Preferred Gate Installation Company
San Pedro homeowners call us because the crew shows up when we say we will, with a written price in hand before any work starts. The Garrison Standard has run our operation since 2008: background-checked techs, a written guarantee on every job, and a live person answering the phone around the clock. No voicemail at 2 a.m. when your gate motor seizes and your car is stuck in the driveway.
We get the repair calls that other shops won’t touch because the job is too fussy. A pedestrian gate set into 70-year-old stucco where the new post has to miss a gas line. A slide gate on a shared driveway where the neighbor needs 24-hour access. San Pedro’s housing stock demands custom thinking, not a parts catalog. That’s what we do.
The reviews from San Pedro customers focus on the same things: the tech put down drop cloths, the gate opens square, and the price on the invoice matched the price on the quote. We answer directly to Lonnie Burke, who owns Carver Gate Repair Torrance, and every job carries the 365-Day Done Right Promise. If it’s not right within a year, we come back and fix it. Free.
Styles & brands we work with
Gate Fabrication in San Pedro
Gate Fabrication in San Pedro means building a gate that physically fits a driveway a catalog gate was never designed for. On the hills above Western Avenue, many gates hang on crumbling 1950s concrete pillars. Before we even talk about automating the gate, we often have to rebuild the pillar itself. You won’t see that conversation happen in flat Torrance or Lomita, but in San Pedro it’s routine.
A new fabricated steel driveway gate in San Pedro typically runs $2,200 to $5,600 depending on the span, the steel gauge, and whether you want a swing or slide configuration. Pedestrian gates run $900 to $2,400 when they’re built to match a house’s existing ironwork or surrounding fence line. Every fabrication job starts with a site measurement, not a drawing on a napkin.
Custom Fit for Tight Pads
Many San Pedro homes have narrow, steep driveways with limited street parking. A standard 12-foot swing gate doesn’t clear. We fab slides and swing gates to the exact pad dimension so they don’t drag on grade changes.
Steel That Handles the Salt Air
We specify galvanized steel frames with powder coat on the uprights and hinges for coastal San Pedro. Bare steel flash-rusts up here within months. The finish work is as important as the weld.
Automatic Gate Installation in San Pedro
Automatic Gate Installation in San Pedro usually means adding an operator to a gate on a slope or a shared driveway, where the control logic has to do more than open and close. We work on LiftMaster, FAAC, Viking, Elite, Mighty Mule, and others, matching the operator to what’s already on the property. A full automatic installation with operator, safety edges, and programming typically runs $2,800 to $6,500 in San Pedro.
Marine-layer moisture is the quiet killer of gate electronics here. Salt-laden fog works into control boards and sensor housings year-round. We use weather-rated enclosures and position boards so they’re not sitting in the condensation path. That’s a San Pedro detail, not a generic one.
Slide Operators on Slope Driveways
Steep driveways put rack and pinion slide operators under constant load. We set the gear rack level with the gate travel, not the driveway surface, which keeps the gate from binding when the grade pitches up.
Shared Access Logic
When a driveway serves another house, the gate has to stay open long enough for both vehicles to clear, and the pedestrian path can’t lock out the mail carrier. We program dwell times, add loop detectors, and wire in free-exit so neighbors aren’t asking us to retune the board every week.
Trusted Brands We Service in San Pedro
We stock and service nine major gate-motor brands, including LiftMaster, FAAC, and Viking. For San Pedro customers that means when a control board fails or a limit switch goes bad, we’re not ordering the part and making you wait two weeks through marine layer season. We carry common replacement components on the truck. El diablo is always in the wiring, so we bench-test the board before we bolt it back into the enclosure.
Common Gate Installation Problems We See in San Pedro Homes
- Swing gate hinges pulling out of aging hillside stucco pilasters. The gate sags, then drags on the driveway concrete and chews up the bottom rail. In San Pedro we see this constantly on homes built before the 1970s where the stucco was the only thing holding the hinge bolts.
- Slide gate operators burning out from marine-layer moisture. Control boards not rated for outdoor salt air corrode quickly up here. We see failed FAAC and Viking boards that fried within two years because the enclosure wasn’t sealed against fog.
- Loop detectors missing low-slung sports cars on steep driveways. A car coming up a sharp grade doesn’t trip a standard loop if the detector sensitivity isn’t set for a low chassis. The gate half-opens, the car noses forward, and it gets hit.
- Crumbling concrete pillars that can’t hold an operator. Bolting a gate operator onto a fractured 1950s pillar is a failed install waiting to happen. We rebuild the pillar first, then mount the arm.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Installation in San Pedro, CA
You should know the numbers before the first call. A new pedestrian gate in San Pedro runs $900 to $2,400. A swing driveway gate, fabricated and installed, runs $2,200 to $5,600. A slide gate with full automation runs $2,800 to $6,500. Pillar rebuilds, when the existing concrete is shot, add $600 to $1,400 per pillar. These are our written ranges for this market. The free estimate we give you is the exact job price – before any work begins, in writing, no door surcharges. Call (424) 757-9824 for a number specific to your driveway.
We Also Serve Cities Near San Pedro
In addition to Gate Installation in San Pedro, we run crews into Harbor City, Lomita, Rancho Palos Verdes, and Carson on short notice. The drive from our Los Angeles dispatch office keeps response times tight across the South Bay, so schedule a free measure and we’ll get you the written number in a day or two.
Serving San Pedro, CA - Our Local Coverage Area
We’re based in the San Pedro area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Installation in San Pedro
Sometimes, but only if the concrete is structurally sound. After 70 years of salt air and seismic settling, most pillars above Western Avenue have hairline fractures that will crack further once an operator arm puts load on them. We test the pillar before mounting anything. If it fails, we rebuild the pillar and re-set the gate, then install the operator. You don’t pay for an operator that rips itself out of the wall in eight months. Call (424) 757-9824 for a site assessment.
Set the rack and pinion gear level to the gate travel path, not the driveway surface. If the driveway pitches up 12 degrees and the rack is installed parallel to the concrete, the pinion geometry binds at the high point. We also set the gate wheels to ride on the level portion of the track and use a heavier bottom rail so the gate doesn’t flex mid-travel. It’s the sort of thing you learn from working hillside driveways, not flat ones.
Yes, if the keypad and boards are rated for outdoor use and the enclosure drains correctly. We mount keypads with an internal weep hole and use silicone-sealed enclosures for the control board. Cheap marine-layer condensation is what kills a FAAC board in San Pedro. We build the enclosure like it’ll sit in fog for six months, because it will.
Yes. We wire in free-exit loops, set the auto-close timer long enough for two vehicles to clear, and add a pedestrian gate that stays live independent of the vehicle gate. Each side gets its own remote and keypad code. If the neighbor needs the gate replaced while yours is being worked on, we schedule around their access instead of locking anyone out for a day.
First, you don’t pay for the fix if it’s inside the 365-Day Done Right Promise window. The written guarantee covers every repair and installation for a full year. If the gate sags because a hillside stucco hinge pulled out, we come back, rebuild the mount, and re-hang the gate at no charge during that window. That’s the Garrison Standard, and it’s in writing before we start.
Contact Carver Gate Repair Torrance for San Pedro Gate Installation
For a free estimate on any gate installation in San Pedro, call (424) 757-9824. A live person answers. We’ll schedule a site visit, take measurements, and hand you a written price before any work starts. The number on the quote is the number on the invoice. That’s how we run every job under the Garrison Standard, and how we’ve run since 2008.
Written by Lonnie Burke, Owner at Carver Gate Repair Torrance, serving San Pedro with the Garrison Standard since 2008.